2009 Chevrolet HHR key fob programming with Tech 2 clone

Success! Have tested Tech 2 clone for 2009 Chevrolet HHR key fob!

The detail… Here you go.

Install the GM Tech 2 scan tool
Turn ON the ignition with the engine OFF
Power On the Scan Tool
Hit Enter
Main Menu > F0: DIAGNOSTICS

Vehicle identification – Model Year > (9) 2009

Vehicle identification – Product Type > Passenger Car

Vehicle identification – Product Make > (1) Chevrolet

Vehicle identification – Product Line > A

Diagnostics > F1: Body

Body> F5: Remote Control Door Lock Receiver

Remote Control Door Lock Receiver > F5: Module Setup

Module Setup > F1: Program Key Fobs

Program Key Fobs > F0: Invalidate all key fobs

Instructions:

The procedure will replace the previously programmed key fob with the key fob requiring programming.

(Follow Instructions, if it don’t work repeat entire procedure)

All desired key fobs must be present.

When the first key fob is programmed, the module will erase the rest of the slots.

The module will fill slots until [Done] or [Exit] is selected.

Note: Only select [Start] once. If the procedure is started again, the control module will start over.

Job’s done! http://www.obdii365.com/producttags/gm-tech2.html

http://www.obdii365.com/service/program-2009-chevrolet-hhr-key-fob-with-gm-tech2-107178.html